Paradyne 12-Port SHDSL Access Multiplexer SAM2000G-12 Manual do Utilizador

SAM2000G-12 12-Port SHDSL Access Multiplexer Also: SAM2000Q-12 (2B1Q) and SAM2000-12 (CAP) 1.0 SDSL ACCESS MODULE MODELS SDSL access

210-0000026 rev07 © Copyright 2003 Net to Net Technologies, Inc. ™ The Net to Net Logo is a trademark of Net

2.0 INSTALLATION 2.1 Unpack and Inspect the SAM2000G If there is visible damage, do not attempt to connect the device; contact Customer Supp

(pins 13-25 and 38-50 are not used) 3.0 SAM2000G DEFAULT CONFIGURATIONS No configuration is necessary for the SAM2000G to operate at default set

3.2 SAM2000G Port Parameters 4.0 SAM2000G MANAGEMENT Once your SAM2000G has been installed, bandwidth and other configurations are softwar

4.1 Via Command Line Interface (CLI) 4.1.1 Establish a Connection With Your IP DSLAM Establish a connection between your IP DSLAM and your PC

4.2.4 Log In Log in with your assigned username and password. For SAM2000G configuration, you must log in as a superuser (general users have read on

The SAM2000G-12, SAM2000Q-12 and SAM2000-12 each have nine SHDSL bandwidth options; default is 272 kbps. Distance capabilities at each bandwidth vary,

concurrently; SAM2000G configurations cannot be saved independently. Once your IP DSLAM has been configured as desired (including the SAM2000G), setti

(A pulsing LED blinks steadily at a rate of once per second. A flashing LED blinks at a more rapid, less constant rate.) 6.3 Regulatory Complianc