Paradyne COMSPHERE 3000 Manual do Utilizador descarregar pdf (Página 73)

COMSPHERE 3000 Series Carrier

3-46 December 1994 3000-A2-GA31-80

Depending on your configuration, use one of the

following schemes for the Models 3151 and 3161 network

interface (Figure 3-33).

• The 50-pin cable can be attached to a

66A-punchdown block. With this scheme, the

circuits must be hard-wired to the block.

• The 50-pin cable can be plugged into a

3100-F1-930 adapter cable. This adapter cable

provides 8 non-keyed modular plugs using Pins 1,

2, 4, and 5. These connect the T1 CSU or T1

DSU/CSU to a standard DDS network interface

(RJ48C) and provide the new JM8-style leased-line

connection for the T1 interface.

To install the Models 3151 and 3161 network interface:

Procedure

1. Connect the network cable to the carrier.

2. If you are using the Telco connector cable, install

the black plastic network cable retainer. If you are

using a straight-in connector, use a small

screwdriver to engage and tighten the screws.

3. Connect the individual cables with 8-pin modular

plugs into the adapter for each T1 line.

Figure 3-33. Network Interface for Models 3151 and 3161 Using an Auxiliary Backplane

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 130 131

Sem comentários

Paradyne COMSPHERE 3000 Manual do Utilizador Página 73