Paradyne 4200 Manual do Utilizador descarregar pdf (Página 131)

5. ATM Commands

4200-A2-GB20-00 August 2002

5-21

RTRV-VCL

The RTRV-VCL command retrieves configuration data associated with an ATM

virtual channel link.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following

acknowledgment response is sent:

IP c

After the above response, a new command input may be generated.

Table 5-17. RTRV-VCL Command Parameters

RTRV-VCL:[tid]:aid_vci:[ctag]::::[pstf],[sstf];

RESTRICTIONS: All parameters in this command are position-defined.

[tid] Identification of the target NE. The default value is null. The NE SID

code is the only other valid value.

aid_vci Virtual Circuit Identifier for the Virtual Circuit. The value can be

preceded with AID=, but this is not required. Grouping and ranging are

allowed. Enter any of in the following formats, replacing lower-case

parameters with the values given:

NTVCL-vpi-vci: VCL in the NT

LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit

– rack: Rack number (1)

– shelf: Shelf number (1)

– slot: LT slot number (1)

– circuit: DSL circuit on the LT (1−24)

– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0−15)

– vci Virtual Channel Identifier (for LT vpi=32−63,

for NT vpi=32−1023)

[ctag] Correlation tag (6 characters maximum) that links an input command

with associated output responses. The default is 0.

pstf Primary State Filter. If no value is specified, this filter is ignored. Valid

values are:

IS: In Service

OOS: Out Of Service

sstf Secondary State Filter. The only valid value is LPBK (loopback).

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 381 382

Sem comentários

Paradyne 4200 Manual do Utilizador Página 131